Kamvalok ® Dry Disconnects -ATERIALS Body, Poppet KAMVALOK® MAINTENANCE !LUMINUM & # -AX 4EMP 334 SEE SEAL CHART !4 !34- " !34- ! #&- , 334 !34- ! #&- 334 !34- ! #&- 334 4 ! #$-#5 $UPLEX 334 3HAFT !34- ! &ERRALIUM 334 !34- ! &ERRALIUM 334 3EALS 3EE #HART 3EE #HART 0OPPET ,INK ! #$-#5 $UPLEX 334 ! #$-#5 $UPLEX 334 3HAFT ,INK ! #$-#5 $UPLEX 334 ! #$-#5 $UPLEX 334 #AM !RMS 3EAL #YLINDER 3EAL /PTIONS +ITS -ATL " " 3" 4EMPERATURE 2ATING "UNA. !, 334 2+, 2+, 2+, 2+, 2+, 2+, & n & # n # &LUOROCARBON !, 334 2+, 2+, 2+, 2+, 2+, 2+, & n & # n # 04&% !, 334 2+, 2+, 2+, 2+, 2+, 2+, & n & # n # EPDM !, 334 2+, 2+, 2+, 2+, 2+, 2+, & n & # n # PART NUMBERS # $ESCRIPTION LEVER ASSEMBLY SHAFT Qty " 1 H32040 H32040 3" C21112RE RK 1 C21119RE C21123RE 1 H32031RE H32030RE H32032RE 2 H20141M H20141M H20144M 5 AUTOLOK™ ARM ASSEMBLY BODY 7 O-RING, MAIN SEAL 1 733ARK-SS20 733ARK-SS20 733ARK-SS30-PADDLE 1 C21120A (EW) C21128A (EW) C21113A (EW) 1 See Seal Options See Seal Options See Seal Options 8 SPRING 9 GASKET 1 H06128M H04328M H10352M 1 See Seal Options See Seal Options See Seal Options + GUIDE, SEAL CYLINDER SEAL CYLINDER 1 H31539M H31540M H31541M + 1 H31542A (EW) H31543A (EW) H31544A (EW) + NOSE SEAL NUT, SHAFT 1 See Seal Options See Seal Options See Seal Options + 3 SPACER 4 GROOVE PIN, CAM ARM LOCK WASHER, SHAFT O-RING, SHAFT STUFFINGBOX O-RING, STUFFINGBOX 1 H32111M H32111M H32111M 1 H31920M H31920M H31920M 2 See Seal Options See Seal Options See Seal Options 1 C20812RE C20812RE C20812RE 1 See Seal Options See Seal Options See Seal Options SHAFT LINK CLEVIS PIN 1 9C21118EW 9C21125EW 9C21111EW 2 H31692M H31692M H31688M POPPET LINK COTTER PIN 1 9C21117EW 9C21124EW 9C21110EW 2 H04981M H04981M H04981M POPPET GUIDEBEARING 1 C21121A (EW) C21129A (EW) C21115A (EW) 1 N/A N/A H32118M NOTE: (EW) 2EPLACES A FOR 334 &ITTINGS *NOTE: Not shown 2 " H32040 + )TEMS INCLUDED IN REPAIR KITS )-0/24!.4 /07 PRODUCTS SHOULD BE USED IN COMPLIANCE WITH APPLICABLE FEDERAL STATE PROVINCIAL AND LOCAL LAWS AND REGULATIONS 0RODUCT SELECTION SHOULD BE BASED ON PHYSICAL SPECIlCATIONS AND LIMITATIONS AND COMPATIBILITY WITH THE ENVIRONMENT AND MATERIALS TO BE HANDLED /07 -!+%3 ./ 7!22!.49 /& &)4.%33 &/2 ! 0!24)#5,!2 53% !LL ILLUSTRATIONS AND SPECIlCATIONS IN THIS LITERATURE ARE BASED ON THE LATEST PRODUCT INFORMATION AVAILABLE AT THE TIME OF PUBLICATION /07 RESERVES THE RIGHT TO MAKE CHANGES AT ANY TIME IN PRICES MATERIALS SPECIlCATIONS AND MODELS AND TO DISCONTINUE MODELS WITHOUT NOTICE OR OBLIGATION + + + + + Kamvalok ® Dry Disconnects KAMVALOK® MAINTENANCE SEALS " /2ING -AIN 3EAL 'ASKET .OSE 3EAL /2ING 3HAFT /2ING 3TUFlNGBOX "UNA. (- (- (- (- (- &LUOROCARBON (- (- (- (- (- 04&% (- (- (- (- (- (- (- (- (- (- (- (- (- (- (- EPDM #HEMRAZ ® " /2ING -AIN 3EAL 'ASKET .OSE 3EAL /2ING 3HAFT /2ING 3TUFlNGBOX "UNA. (- (- (- (- (- &LUOROCARBON (- (- (- (- (- 04&% (- (- (- (- (- EPDM (- (- (- (- (- #HEMRAZ® (- (- (- (- (- 3" /2ING -AIN 3EAL 'ASKET .OSE 3EAL /2ING 3HAFT /2ING 3TUFlNGBOX "UNA. (- (- (- (- (- &LUOROCARBON (- (- (- (- (- 04&% (- (- (- (- (- (- (- (- (- (- (- (- (- (- (- EPDM #HEMRAZ ® INSTALLATION PREPARATIONS WARNING: 2EAD UNDERSTAND THESE INSTRUCTIONS BEFORE STARTING INSTALLATION OR DISMANTLING s #OUPLER TO BE USED FOR ITS DESIGNATED PURPOSE ONLY s ,OCAL REGULATIONS FOR UNLOADING MUST BE FOLLOWED AT ALL TIMES s 0RODUCT mOW MAY RESULT IN STATIC ELECTRICITY GROUNDING OF EQUIPMENT IS REQUIRED s /07 INSTRUCTIONS MUST BE FOLLOWED FOR INSTALLATION OR DISMANTLING AT ALL TIMES s -AKE SURE TO USE ADEQUATE PERSONAL PROTECTION AT ALL TIMES DURING OPERATION s 3ECURE WHATEVER DEVICE COUPLER WILL BE MOUNTED TO EG LOADING ARM HOSE ETC s 4HREAD COUPLER ONTO PIPE USE PROPER THREAD SEALANT MAINTENANCE ATTENTION: 4HE SAME RISKS AND PROCEDURES OF INITIAL INSTALLATION APPLY #ONSIDER THE FOLLOWING WHEN SERVICING THE COUPLER s 7HEN COUPLER IS OVER PRESSURIZED IT MUST BE INSPECTED THOROUGHLY s !FTER MAINTENANCE IS PERFORMED IT MUST BE TESTED BEFORE THE NEXT USE SEE 4ESTING !FTER 3ERVICING s 0ERIODIC INSPECTION EVERY MONTHS FOR LEAKAGES ESPECIALLY WITH TOXIC OR HAZARDOUS MEDIUMS s -AINTENANCE MUST BE PERFORMED BY AUTHORIZED PERSONNEL s 0ERIODIC MAINTENANCE ONCE A YEAR IS REQUIRED ACCORDING TO THE MAINTENANCE INSTRUCTIONS s )N CASE OF PARTS OF COUPLERS BEING REDIRECTED THE INITIATOR MUST PROVIDE INFORMATION ABOUT THE MEDIUMS WHICH HAVE BEEN IN CONTACT WITH PARTS OF THE COUPLER s $URING MAINTENANCE PARTIAL DISMANTLING COULD BE NECESSARY THE SAME RISKS AND PROCEDURES APPLY 0(/.% s s &AX s (ENKLE $RIVE s ,EBANON /( s www.opw-es.com 0RINTED IN 53! Ú #OPYRIGHT /07 %NGINEERED 3YSTEMS 3
© Copyright 2024 ExpyDoc