Removing Side 1 av 4 Removing 1/30/2015 vw-wi://rl/N.en-GB

Removing
Side 1 av 4
Removing
– Loosen 12-point nut on wheel hub.
Caution
Damage to vehicle.
The wheel bearing can be damaged by the weight of the vehicle if the bolt is loosened.
Loosen bolt only when vehicle is standing on its wheels.
– Remove front wheel.
– Remove brake caliper complete with brake carrier and secure to vehicle → Rep. Gr.46.
– Remove brake disc → Rep. Gr.46.
– Remove ABS speed sensors → Rep. Gr.45.
– Unbolt suspension link from swivel joint.
– Using ball joint puller -T40010-, pull suspension link from swivel joint.
– Press drive shaft out of wheel hub using remover -T 10103- and adapter -T 10103/2-.
vw-wi://rl/N.en-GB.k00589824.wi::37424193.xml?xsl=3
1/30/2015
Removing
Side 2 av 4
– Secure drive shaft to body.
– To stabilise the wheel bearing housing, insert suspension link back in wheel bearing housing
and tighten swivel joint nut hand-tight.
– Centre gripping pieces -T10205/12--3- behind wheel hub -1- with wheel bolts -2-.
Note
Wheel bolts -2- must not protrude from backs of gripping pieces -T10205/12--3-.
– Position engine and gearbox jack -V.A.G 1383 A- under wheel bearing housing.
– Assemble tools as shown in figure.
vw-wi://rl/N.en-GB.k00589824.wi::37424193.xml?xsl=3
1/30/2015
Removing
Side 3 av 4
1 - Threaded rod M20 -T10205/8-12 - Nut M20 -T10205/8-23 - Thrust head -T10205/134 - Hydraulic press -VAS 61785 - Bell -T10205/26 - Gripping pieces -T10205/127 - Thrust piece -T10205/38 - Nut M20 -T10205/8-29 - Threaded rod M20 -T10205/8-1-
– Press wheel hub unit with wheel bearing out of wheel bearing housing, holding the tools steady.
Note
When setting bell -T10205/2--1- in place, ensure that the wheel bolts -arrows- are in the positions
shown.
vw-wi://rl/N.en-GB.k00589824.wi::37424193.xml?xsl=3
1/30/2015
Removing
vw-wi://rl/N.en-GB.k00589824.wi::37424193.xml?xsl=3
Side 4 av 4
1/30/2015

Download Report