XS-8K XS-8X - Crossfire Car Audio

Owner’s Manual
XS-8K
XS-8X
FEATURES
9 dB/oct, Variable Bass Boost
o
Dual MOS-FET PWM Power Supply
180 Variable Phase Shift
Stable into 1 Ohm Mono Load
4 Way Protection Circuit
24 dB/oct, Variable Low Pass Filter
(Thermal, Voltage, Speaker Short and DC)
24 dB/oct, Variable Subsonic Filter
Subwoofer Level Controler Included
XS-8K Voltage Range: 8.5V ~16V
XS-8X Voltage Range: 8.5V ~18V
SPECIFICATIONS
Rated Power Output
XS-8K @ 12.5V
XS-8X @ 18V
-RMS Power, 2 Ohm Strapped ------------------------------
16,000W x 1CH
20,000W x 1CH
-RMS Power, 1 Ohm Mono ----------------------------------
8,000W x 1CH
10,000W x 1CH
-RMS Power, 2 Ohm Mono ----------------------------------
4,000W x 1CH
5,000W x 1CH
-RMS Power, 4 Ohm Mono-----------------------------------
2,000W x 1CH
2,000W x 1CH
Low Pass Frequency Crossover -----------------------------------
35Hz~250Hz
Subsonic Filter --------------------------------------------------------
10Hz~50Hz
0~9dB
Bass Boost @ 45Hz -------------------------------------------------
0~180 Degree
Phase Shift Control---------------------------------------------------Frequency Response--------------------------------------------------
15Hz~270Hz (+/- 1dB)
Input Sensitivity-------------------------------------------------------
0.2V~6V (+/- 5%)
90dB
Signal/Noise Ratio-----------------------------------------------------
<0.1%
T.H.D @ 4 Ohm------------------------------------------------------
86%
Recommended Fuse Rating---------------------------------------Operating Voltage ---------------------------------------------------Dimensions-------------------------------------------------------------
800A (External Type Fuse)
8.5V~16V
8.5V ~ 18V
11.33(W) X 2.58(H) X 34.65(L) Inches
e products without notice.
POWER CONNECTIONS
HEAD UNIT
FUSE
800A
GROUND
GROUND
BATTERY
Caution
This amplifier is not supplied with a internal fuse.
Make sure you install a in-line fuse holder
from the postitive (+) terminal of battery.
Recommend 800 Ampere fuse.
+12V Power
Connect the +12V terminal of the amplifier to the positive (+) terminal of the battery using the same diameter
cable as the ground cable, making sure you install a in-line fuse holder, approximately 300 or 400 mm.
from the positive (+) terminal of battery.
GROUND
Disconnect the battery and connect the GND (ground) terminal to the cars chassis.
Keep this cable as short as possible (not longer than 20 inches or less).
Making sure that the connection with the chassis is rust free and clear of paint or grime.
REMOTE
Connect the REM terminal of the amplifier to the power antenna terminal in the car ignition switch
using 12 or 14 ga. electrical wire.
RCA & SPEAKER CONNECTION
XS-8K & XS-8X INPUT CONNECTION
HEAD UNIT
Wired Remote Control
XS-8K & XS-8X SPEAKER CONNECTION
4 ~ 1ohms
XS-8K & XS-8X Speaker Connection 1
4 ~ 2ohms
XS-8K & XS-8X Speaker Connection 2
4 ~ 2ohms
DUAL AMP INPUT & SPEAKER CONNECTION ( STRAPPED )
MASTER & SLAVE RCA CONNECTION
"MASTER UNIT"
HEAD UNIT
4~2ohms
"SLAVE UNIT"
positive terminal of the subwoofer's voice coil
must be connected to the positive terminal of the MA
of the subwoofer's voice coil must be connected to po
When wiring two amplifiers to a single subwoofer, please make sure power handling capabilities will
not be exceeded.
Caution !!
When in strapped mode connection, XS-8K & XS-8X the minimum working impedance
is 2 Ohms. Any impedance (load) lower than 2 Ohms can damage the amplifiers.
DUAL AMP POWER CONNECTION (STRAPPED)
POWER CONNECTION
Remote Turn-On
FUSE
800A
GROUND
GROUND
BATTERY
FUSE
800A
GROUND
GROUND
BATTERY
Caution !!
XS-8K Operating Voltage: 8.5V to 16V at 1Ohm.
XS-8X Operating Voltage: 8.5V to 18V at 1Ohm.
Strapped Minimum Impedance is 2 Ohms.
TROUBLE SHOOTING
prevent any damages from misuse or faulty conditions.
If XS-8K & XS-8X sense excessive heat, short circuited speakers DC, or voltage the protection indicator
to check the problem, you should turn all levels down
for wiring mistakes or short.
If XS-8K & XS-8X shut down due to excessive heat, they will remain in thermal protection until amplifier reaches
normal operating temperature. Before removing your amplifier, refer to the list below and follow the sugguested
proceedures.
NO OUTPUT
Check remote turn-on voltage at amplifier and headunit, when remote turn-on voltage is low
or no turn-on voltage, there is no sound.
Check fuses at the battery side or external fuses and all wire connections.
Check RCA Input is properly connected.
AMPLIFIER SHUT DOWN ( PROTECTION )
Please check POWER, GND and REMOTE wire connection and other wires properly connected.
When DC is over 4V at input, try by replacing head-unit or source.
on after it cools down. Please install amplifier in a better ventilated area.
XS-8K & XS-8X have a minimum working impedance of 1ohm as single unit. Strapped connection is 2 ohm
XS-8K voltage protection at low and high is 8.5V ~ 16V, XS-8X is 8.5V ~ 18V.
Make sure Chassis and Remote use same GROUND.
DISTORTION & NOISE
Check all ground connections of all other audio equipment.
POOR BASS RESPONSE
Check speaker wiring and reverse polarity.
Crossfire Car Audio
3247 Story Rd. West
Irving, TX. 75038
972.570.0800 or 800.332.2771
www.crossfirecaraudio.com

Download Report