FOR SALE: USED GAS TURBINE Recently DDM became owner of the Hemweg 7 power plant which is out of operation since December 2012. Since that moment precautions are taken to ensure that the equipment of the power plant stays in its perfect condition. The plant consists of one direct fired boiler installation, heavy fuel oil (HFO) and gas, and a steam turbine in combination with a gas turbine. The gas turbine is able to run in combination with a boiler and steam turbine or seperatly. The boiler and steam turbine were commissioned in 1978. The gas turbine GT13E which has been taken into operation in 1988 is available. The new EV burner unit has been installed in 1996. FOR SALE GAS TURBINE 02 The steamturbine consits of a high pressure, medium pressure and two low pressure turbines. FOR SALE GAS TURBINE 03 Gas Turbine: Manufacturer: Capacity: phi 0,8) Frequency: Year: Speed: Fuel: Last C-inspection: Hours: Trips 296 Emission: Turbo generator Alstom/ABB, Model GT13E 150,000 kW (150MWE/18,5 MVA, cos 50 Hz 1988 3000 RPM Gas 2004 OH 66.200 EOH 95.644 Starts 1.456 Manufacturer:ABB, Model: WTAL 534 Serial nr.: GM 204791 Capacity: 187.500 KVA Speed: 3000 RPM Volt: 15.000 V Frequency: 50 Hz NOx 75 mg/Nm3 Additional equipment Kawasaki Ammonia De-Oxidation Method, DLN Combustor Technology, EV Type Burners. Misc. spare parts. Note: New EV burner unit has been installed in 1996. FOR SALE GAS TURBINE 04 Configuration Unit: Net: FVR: Fuel: GT Conventional BST BST = NHN 150 kV, GT = A 50 kV Yes LC gas, HC gas, LC gas-oil, HC gas-oil Shutdown Restrictions Shutdown a unit regularly can be done in respect to two aims, i.e. being available for production as fast as possible or being available for maintenance as fast as possible. We distinguish therefor two types of shutdown: Shutdown Warm, Shutdown Cold The stop procedures describe from a specific amount of power output which special restrictions occur. The format equals the format of the control restrictions. Characteristics of the old configuration Power output depends on air and cooling water temperature. Therefore temperature curves are set for planning purposes. Sliding Heat Curve (GWK) per 1-1-2003 Properties The calling time is the time needed for a Powerplant to come standby and is downtime dependable. The start time is the time needed to come from standby to parallel and is also downtime dependable. Control Restrictions (Regelrestricties or Ramping) Per specified call time control restrictions are given. Once a unit delivers power, for all start types maximum control restrictions apply. The maximum control restrictions are noted points in time and net power output. The maximum control restrictions are valid if the unit is ramped up to its maximum. In the ranges between the dictated points, more points can be described. P = netto opwek in [Mwe] Q = warmtelevering (5min waarde) [MWth] Tkw = Koelwatertemperatuur inlaat KK Tbl = Buitenluchttemperatuur WvB = Warmteverbruik sWvB = Specifiek warmteverbruik NOx Emission FOR SALE GAS TURBINE 05 FOR SALE GAS TURBINE 06 FOR SALE GAS TURBINE 07 For any questions please contact Menno Boot on phone number +31 (0)30 666 97 80 or cell phone +31 (0)614 671 554 [email protected] DDM Demontage B.V. Veldzigt 62, 3454 PW PO Box 253, 3454 ZM De Meern, the Netherlands