Bailey Morris Ltd. Little End Road - Eaton Socon - Huntingdon - Cambs PE19 8GE - Tel: (01480) 216250 td L ris r Mo 1140 series 2pce shaft high spec build. FOR BIKE ENGINED VEHICLES Dynamic balance 3,000rpm ISO 1940 Q16 d t Gearbox end y L e l i s a i B r r o M s y i r le i r o Ba M Prefered option no.1 is to have sliding option always in rear section. Centre bearing should be used to ensure slight pressure on gearbox flange. Please provide as much information as possible to ensure correct shaft is supplied. Please ask if configuration is unclear or you require non standard installation Option 1 mm Fixed Length Option 2 y e l i a B mm Fixed Length Std 109mm machined forgings for weight reduction approx 12% Non greasable u/joints Customer BMCB57 Working length (mid slip) OR Fully Closed Axle flange options dia. (please enquire on hole spacings) Resilient 109mm (Fy1.6) 56mm reg y e l i a B Centre brg options High Spec u/joints d t L s i r r o M Diff.End 50.8mm Resilient Resilient tube (only required in 1 section) Working length (mid slip) mm OR Fully Closed Rear Tube dia options 50.8mm 87mm Diff. End d t L mm Front Tube dia. options Gearbox flange options (dia) Fax: (01480) 403045 [email protected] Ford 4 bolt (10.1mm) 90mm p.c.d. 87mm (Fy1.1) 57mm reg 1140 4 bolt (8.1mm) 69.85mm p.c.d. 97mm (Fy1.12) 57mm reg 4 bolt (10.1mm) 75mm p.c.d. Freelander 92mm (Fy1.5) 57mm reg 4 bolt (9.7mm) 76mm p.c.d. Rover Other BMCB131 Phone no. 2pce Questionaire Kit