Technical Specifications Technical Data Testing Method Test Data Thickness 1.5mm Tensile strength to break EN 12311-2 ≥11 N/mm2 Elongation at break EN 12311-2 ≥200% Static puncture resistance EN 12730 (A) Impact resistance EN 12691 ≥600 (Hard substrate) ≥1000 (Soft substrate) Tear resistance EN 2310-2 ≥150 N Joint separation resistance EN 2310-2 ≥150 N Reaction to fire EN 13501 -1 :2002 E (EN ISO 11925-2) Water tightness EN 1928 : 2000 (B) Pass Root Resistance EN 13948 : 2008 Pass *Properties (Barcelona Test) WARRANTY Uniseal® PVC For warranty issues and other information, please contact the manufacturer for full details. HIGH PUNCTURE RESISTANT // HIGH UV RESISTANT // UNIFORM THICKNESS // EXCELLENT FLEXIBILITY Uniseal Creative Solutions Pte Ltd 31 Mandai Estate, Innovation Place, IMMEDIA #06-04 Singapore 729933 Tel : (65) 6755 0055 Fax: (65) 6753 1398 Email: [email protected] www.uniseal.com.sg Disclaimer Information contained herein are printed to the best of our knowledge and is supported by current available data. Subjected to the care and method of application, deviations in performance may occur. The manufacturer is not responsible for any loss or damage arising from incorrect usages. Our guarantee is therefore limited to the quality of the supplied materials. For more information on the product and installation, please call Tel: (65) 6755 0055. ISO 9001 ISO 14001 ISO 18001 Copyright reserved 2012 Greener Today For A Better Tomorrow.” PVC “A STEP. 4 STEP. 5 PRODUCT DESCRIPTION Uniseal® PVC is a 1.5mm thick single-ply membrane with non woven glass fibre reinforcement. The attribute of superior performance of the membrane allows it to be used in different type of roofs and landscape areas. Uniseal® PVC is a durable, strong & flexible membrane that is fully adhered to the roof surfaces. STEP. 1 STEP. 3 STEP. 6 APPLICATION STEP. 2 Uniseal® PVC membrane has been tested and certified as resistance waterproofing membrane in accordance with the UNE-EN 13948:2008 standard. AREAS OF USAGE All type of roof surfaces, sky gardens, environmental deck, car parks SURFACE PREPARATION Ensure all substrates are firm, clean, dry, free from grease, curing compound and any loose materials or protrusions, prior to application. New concrete or plastered surfaces must be cured for a minimum 28 days. Existing old structure surfaces must be jet washed and allowed to dry for 2 to 3 hours prior to application (depending on weather condition). Cracks and joints must be repaired using suitable compound prior to application. SAFETY PRECAUTION Take all safety precautions for workmen such as helmets, goggles, protective gloves, overalls, safety boots etc. Unroll the membrane to achieve correct over lapping joint and alignment prior the hot air welding. (All side laps must be 50mm wide and end laps 75-100mm) PACKAGING Roll back the membrane and start to apply adhesive to the surfaces prior installing the system. COLOUR AVAILABILITY Unroll the membrane slowly and use the roller to remove any trap air bubbles to achieve full bonding to the surfaces. At all side & end laps, use the hot weld machine to bond the 2 pcs membrane to achieve the strong and tight over lapping edges. (Temperature must be controlled, do not over heat) 2.05 x 20m Roll Grey OCCUPATIONAL SAFETY AND HEALTH As high temperature machine are used during application, extra safety procedure need to be taken. STORAGE Store the membrane in sleeping position.