Solo-Prime Electronic Trap Primer SP-500-24V and SP-500-115V

Solo-Prime Trap Priming Manifold
Trap Primer valves
Precision Plumbing Products
AD
LE
“Specify with Confidence - Install with Pride”®
EE
FR
SOLO-PRIME ELECTRONIC
TRAP PRIMING MANIFOLD
www.pppinc.net
ELECTRICAL SPECIFICATIONS:
1/2”NPT
POWER REQUIREMENTS:
SUB MINIATURE
SOLENOID VALVE
24 VAC
6.3 WATTS
60 Hz
1 Phase
2 wire + ground
Hold current .54 Amps
In Rush 1.2 Amps
8 15/16”
APPROVED BRACKET
LOCATIONS WHEN
ALIGNMENT
LEGS ARE REMOVED
6 7/16”
1”AIR
GAP
120 VAC
6.3 WATTS
60 Hz
1 Phase
2 wire + ground
Hold current .11 Amps
In Rush .23 Amps
TEMPERATURE PRESSURE:
32°F - 125°F, 20 PSA - 150 PSI
MODEL NO:
SP-500-24V
SP-500-115V
SOLENOID VALVE
ELECTRICAL CORD
6’ STANDARD
1/2”FEMALE N.P.T.
“SOLO-PRIME” has been designed to interface with the
low voltage energy management systems used to control
the special services found in many commercial buildings.
“SOLO-PRIME” is a priming assembly consisting of:
subminiature solenoid valve, physical air gap and a 6’
electrical cord. It can be placed anywhere in the piping
system. By incorporating the precision plumbing distribution units it reduces the cost per drain served.
The Trap Primer valve make up line to floor drain is recommended to be a minimum of 12” off the finished floor
before a 90˚ elbow can be installed. The furthest distance
of makeup line is approximately 20’ to floor drain. Trap
primer make up line must have a continuous slope to the
floor drain (consult local code requirements).
PROJECT SUBMITTAL
Project:
Contractor:
Engineer:
Date Submitted:
Prepared By:
ASSEMBLED IN ACCORDANCE WITH ANSI/ASME A112.1.2
AIR GAP IN PLUMBING SYSTEMS STANDARD
Precision Plumbing Products
Division of JL Industries, Inc.
802 SE 199th Ave
Portland, Oregon 97233
T (503) 256-4010
F (503) 253-8165
www.pppinc.net
Rev 06/13

Download Report