1 2 3 4 5 6 7 OUTLET 8 NOZZLE TABLE N2 INLET N1 AIR INLET ANSI150# 5'' RF slip-on 615, 190, 1396 N2 AIR OUTLET ANSI150# 5'' RF slip-on 995, 410, 1445 N3 PRESSURE SAFETY VALVE ANSI150# 5'' FF slip-on 665, -250, 813 N4 MANUAL DRAIN VALVE 1/2 '' NPT 665, 190, 815 N1 A X, Y, Z-VALUES Baseplate position holes tolerance 5mm Connections tolerance 10mm 12 6 4 584 N4 CAUTION NOTE 3 CABLE ENTRY 1x 1/2'' NPT Always use flexible couplings when connecting to rigid pipes. Protect the machine at least with a shielding roof when installing in the open air. N3 NOTE 4 9 7 1455 1445 B Foresee a clear area of at least 1m around the group in order to permit the disassembly and the maintenance. 1406 CABLE ENTRIES 2x M32x1,5 1x M20x1,5 A 3 B 600 550 10 813 2 M16/M18, A2-70 823 CoG Z: 750 5 1m 11 C C 1 8 1000 DATUM POINT 50 100 10 100 1200 25 1m 550 10 DATUM POINT 1m 1200 1000 13 25 600 1m 25 M22 x4 FOR LIFTING 1150 25 25 MAINTENANCE AREA FOOT PRINT SCALE 1:20 10 70 CENTER OF GRAVITY X 665 COG COORDINATES Y Z 265 750 E EXAMPLE OF THE EQUIPMENT SUPPORT ARRANGEMENT IN ONE CORNER SCALE 1:6 CoG X: 665 250 25 DATUM POINT 20 CUBILITY SCOPE YARD SCOPE 190 850 410 220 335 550 CoG Y: 265 E 40 D 190 D 535 615 380 205 PLANT NOTES: F Drawing number Rev. Drawing number DRW10227 Rev. 01 1 2 DRAWING TITLE: F GENERAL ARRANGEMENT DRAWING, VACUUM PUMP UNIT MUD CUBE 01 15-08-14 3 - 1. WEIGHT: 420 KG, NO ITEM >25KG ARE TO BE REMOVED FOR MAINTENANCE 2. USED FOR MAINTENANCE PURPOSES ONLY AND TO CHECK FOR MOISTURE IN THE FILTER 3. TO BE COVERED WITH SAFETY GUARD MESH ACC. TO GRADE IP20 4. NO LOADS ARE ADMISSIBLE FOR INLET, OUTLET AND VACUUM RELIEF FLANGE OF THE TBT. PIPING HAS TO BE SUPPORTED AND EXPANSION JOINT HAVE TO BE INSTALLED BETWEEN PIPING AND TBT-FLANGES. 5. SURFACE COATING AND PROTECTION ARE IN COMPLIANCE WITH NORSOK M-501 REV. 4 DATE 5 ISSUED FOR INFORMATION LKW REASON FOR ISSUE SU KH 1:10 SCALE 6 AT A3 D370 11 SIZE AREA SYSTEM 7 - DRAWING NUMBER 8 REV.