Maintenance components and EPS electronic

MAINTENANCE
CAUTION
Periods and riding distances are purely indicative and may be significantly different in relation to conditions of use and the
intensity of your activity (for example: racing, rain, salted Winter roads, weight of the rider etc.). Check with your mechanic
to select a schedule that is best for you based on your size, riding conditions and you riding style.
IMPORTANT
Although the system meets the IP67 standards of water infiltration resistance, we would not recommend washing
the bicycle with pressurised water and aggressive detergents.
Never spray your bicycle with water under pressure. Pressurized water, even from the nozzle of a small garden hose,
can pass seals and enter into your Campagnolo® components, damaging them beyond repair. Wash your bicycle and
Campagnolo® components by wiping them down with water and neutral soap. Dry them using a soft cloth. Never
use abrasive or metal pads.
1 - EPS ERGOPOWER CONTROL LEVERS
• Ergopower™ control levers must be checked by a specialist mechanic every 3 years or every
30,000 Km (18,000 miles). The cables and casings must be replaced every 2 years or after
20,000 Km (12,000 miles).
• In the event of competitive use, Ergopower™ control levers must be checked by a specialist
mechanic and cables and casings must be replaced every year or every 15,000 Km (9,000
miles).
• Lever 1 can be replaced as with mechanical systems.
2 - EPS FRONT DERAILLEUR
• Periodically clean and lubricate the pivots of the derailleurs with a suitable oil for thermoplastic components.
• Be careful not damage the component because the 3 pivots are inserted with a press since
they have a knurled area for an interference fit. Use Molikote 40 grease on the pivots.
• The cage can be replaced as with mechanical systems.
1
3 - EPS REAR DERAILLEUR
• Periodically clean and lubricate the pivots of the derailleurs with a suitable oil for thermoplastic components.
• If the rollers do not rotate smoothly, clean throughly and replace if necessary.
• To remove the rollers, unscrew the screws with a 3 mm Allen screw.
WARNING!
The two rollers are different: on the upper section, fit the roller marked “UPPER” (with
side play); in the lower section, fit the roller marked “LOWER”: it is unidirectional and
must be fitted so that it rotates in the direction indicated by the arrows.
WARNING!
Comply with the following specifications when replacing the pulleys:
Tightening torque
2,7 Nm (24 in.lbs)
4 - POWER UNIT
As the power unit EPS contains the battery pack, the following precautions must be
observed:
• Only use the battery charger supplied with the EPS drivetrain.
• Do not dismantle or modify the power unit EPS.
• Do not use the power unit EPS in the case of visible external damage.
• Do not use the power unit EPS if any of the components are damaged or in unsuitable
ambient conditions.
• Keep the power unit EPS in a safe place out of reach of children and animals.
DANGER!
Do not heat or burn the power unit EPS. Do not leave the power unit EPS in places
where the temperature may exceed 60°C (e.g. in a car on a hot day or near fireplaces or heaters). Failure to observe these instructions may cause overheating, fire or
explosion and result in severe injury or death.
If you do not intend to use the power unit EPS for a prolonged period, it must be switched
off (by inserting the magnet in the respective seat) and kept in a safe place. We recommend
checking the battery charge level and fully charging the battery approximately once every
six months.
In order to prevent damage to the system battery pack, the system automatically switches
off when it reaches 9 Volts to prevent dropping under this voltage.
If 7.2 Volts are reached, the system also shuts down other electronic components to prevent
further energy absorption, protecting the battery from damage.
We therefore strongly recommend recharging the battery once the interface LED turns off.
IMPORTANT!
Never use denatured alcohol to clean your EPS Power Unit.
2
MAINTENANCE
COMPONENTS
EPS
Please contact a Campagnolo Service Center or a Campagnolo Pro-Shop for information on correctly disposing of your
EPS Power Unit.
5 - INTERFACE
IMPORTANT!
Never use denatured alcohol to clean the interface unit.
6 - BATTERY CHARGER
• As there are no user-serviceable parts inside the unit, do not open the EPS battery charger
for any reason.
• The EPS battery charger may only be used indoors and must not be exposed to rain or
humidity.
• The EPS battery charger must only be used to charge the battery pack for the Campagnolo
EPS power system.
WARNING!
Only use the power cable provided with the battery charger for use with mains power,
or the specific cable for use with 12 VDC power from a vehicle power socket (available
as a spare part). Using cables other than those specified by Campagnolo s.r.l. may cause
electric shock, explosion, fire, injury or death.
• Always disconnect the EPS battery charger from the mains when not in use.
• In the event of malfunction, do not attempt to open or repair the unit in any way, and take the unit to a Campagnolo service center or
pro-shop.
• Keep the EPS battery charger out of the reach of children and animals.
IMPORTANT!
Never use denatured alcohol to clean your EPS battery charger.
Please contact a Campagnolo Service Center or a Campagnolo Pro-Shop for information on correctly disposing of your EPS battery
charger.
3

Download Report