S-HJT/3/3W c/w LED/40/NL - No Lens (Wide Angle) S-HJT/3/3W c/w LED/40/OA - Open Area Lens S-HJT/3/3W c/w LED/40/CO - Corridor Lens The kit is a standalone unit designed to provide maintained or non-maintained, three hour duration, emergency lighting using a variety of ceiling mounting 3W LED 700mA Minispot units. The units use a 3.6V 4.0 Ah Nickel Cadmium (NiCd) battery to provide a full 700mA output to the LED Emitter in emergency conditions. Installation Instructions 1. Cut a 40mm diameter hole in the ceiling tile. 2. Connect the LED Bezel to the main assembly via the 4 way connector. 3. At the supply side of the 3 pole mains connector connect the Unswitched (Battery Charging) 240V supply to the 1-L1 Unswitched Live terminal. Connect the Neutral supply to the 2-N Neutral terminal. The unit is class II double insulated and no earth is required. 4. If maintained operation is required connect the Switched Lighting 240V supply to the 3-L Switched Live terminal. 5. Connect both halves of 3 pole mains connector together. 6. Only connect the battery when the Unswitched supply is fully assured. Even though these units are protected with a Deep Discharge Protection Circuit, the Batteries can be damaged by being left in an uncharged state for prolonged periods. Ensure correct polarity. 7. When the supply is present and the battery connected, check that the green LED indicator is illuminated showing that the supply is healthy and the batteries are charging. 8. Pass the whole assembly through the 40mm aperture and clip the LED housing into the ceiling. Technical Information 220-240 Volts AC 50/60 Hz 7.1 Watts 3.0 Watts 3 Hours 3.6V 4Ah Nickel Cadmium 200mA 24 Hours 100% 4V DC 1.0 Amps 70°C Module / 55°C Battery 3 Watts 700mA 40mm 110mm Module 150g/Battery 400g Input Voltage Power Rating – Maintained Power Rating – Non Maintained Emergency Duration Battery Type Charger Recharge Time Ballast Lumen Output Maximum Output Voltage Battery Discharge Current Tc Max Output Load for LED Output Current for LED Ceiling Cut Out Minimum Void Weight No Lens (Wide Angle) Open Area Lens Corridor Lens Temperature 6500K 6500K 6500K Lumens 170 160 157 Separate data sheets are available on the various 3 Watt emitter heads. 3 Cell 4Ah battery 1-L1 2-N 3-L Unsw Neutral Switch Live Live 230/240V AC Input Connect mains supply to 3 way plug 1-L1= Unswitched Live 2-N = Neutral 3-L = Switched Live Colour Cool White Cool White Cool White For Non-Maintained use do not connect to 3-L = Switched Live Emergency Module XXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXX XXXXXXXXXXXXXX 2 pole Battery connector 4 pole Low Voltage Plug 3 Watt LED Emitter Issue 1403
© Copyright 2024 ExpyDoc
