Installation Guide (PLT-416)

C COPYRIGHTS 1998
Website: www.remacotech.com
REMACO TECHNOLOGIES PTE LTD
V: 2.0
Installation Guide
(PLT-416)
PLT
Caution with main supply and live wires. Install with qualified technician or trained
personnel.
Warning
Warning
Types of Installation Mount
Steps
Installation
Steps
for for
Installation
Step
Step 1
1
Back
35
Front
10mm Drill
Adjustable
20-32cm
Ceiling Mount
Power Drill
Back
Front
Ceiling Suspension
55.0cm
PLT-416
A) Drill Dia. 10mm holes to a depth of 35mm.
(Note: Do not drill too deep)
Step
Step 2
2
39.0cm
55.0cm
M8 Threaded
(Optional)
cm
64.5
12 x 4 Nos.
10.00 cm
M8 Anchor
10.00 cm
Connect
to the MPC
Pin Punch
MPC-850
Motor Power Control
Hammer
B) Insert M8 anchor into the hole.
C) Use pin punch to expand the anchor.
Step
Step 3
3
MPC-850
Motor Power Control
Important Note
All connections
are to the MPC
For connection details,
please refer to the
Installation Guide
provided
Adjustable
24 cm
to
320 cm
AVA-210
Sensor
AVA-301
2-Channel
Infrared Remote
STOP
STOP
AVA-200
Wall Swtich
5.50 cm
cm
70.0
50.8 cm
Projector
Step 4
Frame
82.0
cm
55.0 cm
Upper Limit (no need adjust unless required)
Press “UP button” and adjust motor upper limit “ - “ (lift move away
from the frame) Then adjust upper limit “ + “ and let the lift move
more into the frame until reaches maximum height (scissor bars just
about fully close)
Lower Limit
Press “Down button” and adjust motor lower limit “-“ to have
less drop first. Adjust lower limit “+” to let lift have more drop
to required height.
Bottom View
(Motor)
+
-
-
D) Connection of all cables to the
MPC-850 (Refer to Installation
Guide for MPC-850)
+
Projector Lift
White Knob
(lower limit)
Red Knob
(upper limit)
Alen Key Adjusting Tool
(to set knob limit switch)
Important Note
Do not adjust the Upper Limit of the lift higher than the original factory preset position. If adjusted, the lift will move into the frame and be stopped by force and not the Upper
Limit Switch. This will cause overheating of the motor, rendering the lift to being unable to operate properly.
Projector Spider Bracket
To be
mount onto
PLT Base
Important Notes:
All spider brackets are thoroughly inspected and fully
tested operational in factory. We accept no liability
whatsoever for any losses due to improper operation,
or any unauthorized alternation. All trademarks contained
in this installation guide are the property of their respective owners.
False Ceiling Support
Option 1
M6 Threaded Rod
M6 Washer & Nut
False Ceiling (Tile Ceiling Board)
Option 2
M6 Threaded Rod
Wood or Board
(Not provided)
Partition Screws
False Ceiling (Plastor Fiber Ceiling)
End
M6 Washer & Nut

Download Report