NOTES: 1. WARNING: This drawing does not illustrate the installation methods required for hazardous locations. Prior to any installation in a Classified Hazardous Location, verify installation methods by the Control Drawing referenced on the product’s name tag and national and local codes. 2. To access the XMV termination board, remove the enclosure rear cover. 3. For RTD installation, remove jumpers from XMV terminals 11-12, 13-14 and the 178Ω resistor from terminals 12-14. 4. The RS-485 buss must be wired in a daisy-chain configuration. Star configurations are not allowed. 5. Maximum accumulated length for the RS-485 buss is 4000 feet. 120Ω – 250Ω Resistor The last XMV on the buss should be terminated with this resistor jumpered across the COMM + and COMM – terminals (the 178Ω resistor discarded in Note 3 is acceptable for this termination). RS-485 Communications Module Totalflow P/N 2015193-002/003 In this configuration, COMM1 may not be used to communicate with other devices. To attach other devices, such as other flow computers, use COMM2 ABB XMV 267/269CS ABB XMV 266CS 3 178Ω Resistor To terminate the Buss on the XRC Board, jumper J7 Pin-1 to Pin-2 1 RS-485 Cable Entry (Wiring Diagram is shown outside of conduit for clarity) J7 9 J18 DISPLAY 5 2 1 J15 MMI BATT BUS + BUS VBATT 3 3 J17 1 1 COMM 1 J4 J6 SHLD GND RS-485 Cable, 6-Conductor P/N: 2011648001 J6A-6 BUSJ6A-8 BUS+ 1 COMM 2 XA2 34 33 1 XA1 J7 U8 PROM GND COMM2 COMM1 J6A-1 VBATT 1 J6A-2 GND 9 DIGITAL I/O B BLK BLK WHT WHT FLASH ON SEE NOTE 3 + CHARGER INPUT J10 U1 J19 KEYPAD - J16 6 I/O EXP J13 + 14 13 U7 SRAM 2 1 1 - A SECURITY J8 S1 OFF (-) XRC Board 2100355 AUXPWR OUTPUT XBT1 RTD Probe P/N 2011905 Connect the Shield GND from the RS-485 cable at the enclosure end of the cable to the Chassis GND Lug located on the bottom of the enclosure. For every other RS-485 cable to an additional device, attach Shield GND to Shield GND. DO NOT ground at any other place. J20 (+) J23 1 2 3 4 5 6 7 8 9 10 TOTALFLOW Products ACTION DOC TYPE L34451 UD TITLE XRC G3 (2100355 BOARD) COMM1 (RS485) TO ABB 267CS & ABB 266CS W/RTD DWG NO. REV 2105114 AA SHEET 1 OF 1
© Copyright 2024 ExpyDoc