Colour Samples Taken from PSD file COOLTEQ Dark Grey Blue WEB: R = 0% G = 109% B = 168% PRINT: C = 97% M = 54% Y = 12% K = 0% world leader in Envelope Tracking COOLTEQ Light Blue WEB: R = 0% G = 177% B = 240% PRINT: C = 93% M = 0% Y = 0% K = 0% COOLTEQ Green WEB: R = 128% G = 195% B = 66% PRINT: C = 55% M = 0% Y = 100% K = 0% COOLTEQ Bright Orange WEB: R = 253% G = 185% B = 19% PRINT: C = 0% M = 30% Y = 100% K = 0% NCT-L1300 Envelope Tracking IC for LTE Smartphones and Modems Nujira’s Coolteq.L family of Envelope Tracking Power Amplifier power supply modulators are the industry’s highest performance ET chips for 3G and 4G smartphones. Supporting the full 20 MHz bandwidth needed for LTE, the NCT-L1300 delivers twice the power savings of lower bandwidth ET or fast switching APT components. Features Using industry-standard MIPI RFFE and eTrak interfaces, Coolteq.L is compatible with the vast majority of ET-ready LTE platform chipsets. Fast mode transition times and a simple, single-byte MIPI RFFE mode change command make it easy for chipset vendors to integrate the NCT-L1300. • 20MHz RF channel bandwidth in ET mode The high slew rate, low output impedance and wide voltage swing range of the NCT-L1300 allows simple ISOGAIN™ linearization of most GaAs and CMOS PAs, without needing complex Digital PreDistortion in the chipset. The high power output capability and buck-boost architecture eliminates the need for MPR, typically delivering 28dBm or more at the PA output, even for LTE signals with high PAPR. Fully backed by Nujira’s world class ET systems expertise and support, and protected by more than 200 patents worldwide, the NCT-L1300 makes Envelope Tracking easy. • Support for 3G, FD-LTE and TD-LTE waveforms • Wide 0.5V - 4.5V output swing range • Does not require DPD • Supports low battery voltages down to 2.5V • 80% efficient • 1.2W average output power • Low output impedance for driving multiple PAs • Compatible with all ET-ready GaAs and CMOS PAs • MIPI RFFE controlled ET and APT modes • Fast mode transition time (2 us typical) • MIPI eTrak/OpenET analog envelope interface • ISOGAIN™ feedforward PA linearization • ACLR/EVM compliance under load mismatch • 0.18u CMOS process, WL-CSP package Colour Samples Taken from PSD file COOLTEQ Dark Grey Blue WEB: R = 0% G = 109% B = 168% PRINT: C = 97% M = 54% Y = 12% K = 0% COOLTEQ Light Blue WEB: R = 0% G = 177% B = 240% PRINT: C = 93% M = 0% Y = 0% K = 0% world leader in Envelope Tracking COOLTEQ Green WEB: R = 128% G = 195% B = 66% PRINT: C = 55% M = 0% Y = 100% K = 0% COOLTEQ Bright Orange WEB: R = 253% G = 185% B = 19% PRINT: C = 0% M = 30% Y = 100% K = 0% Nujira’s patented ISOGAIN™ linearization delivers improved linearity, ACPR and EVM, without requiring complex DPD. 27 dBm LTE 10-15dB ACPR improvement with Coolteq.L ET APT mode -34 dBc 20% saving 30% saving 25% saving Lower Power 30 This enables terminals to deliver full power 23 dBm LTE signals to the antenna, eliminating the need for MPR, improving network coverage, boosting data rates, and minimising power drain. ISOGAIN also delivers significant ACPR and EVM improvements into heavily mismatched antenna loads, delivering cleaner signals and more output power in real-world conditions. Coolteq.L ET mode -48 dBc Cool Smaller Products Measurements of commercial GaAs PA at 23dBm transmitted RF power comparing traditional DC/DC converter and Coolteq.L Envelope Tracking DC/DC converter 20 40 50 10 Mbps Faster Data Global Better Coverage Nujira’s Coolteq.L Envelope Tracking IC replaces a traditional DC/DC converter, boosting PA efficiency to 50% and beyond, even for LTE signals with high peak-to-average ratios. The high bandwidth and wide ET swing range of Coolteq.L can linearize the PA without DPD, delivering up to 10 dB of ACLR improvement using a simple, feed-forward architecture. Targeted at 4G smartphones and data modems, Coolteq.L saves power, boosts data rates, improves signal coverage and reduces temperature, enabling terminals to deliver a true 4G experience. Coolteq ET modulator PA dissipation (DC/DC) PA dissipation (Coolteq) RF front end losses Transmitted RF (200mW) 3G (W-CDMA) 4G (LTE QPSK) 4G (LTE QAM) Measured ET instantaneous PA efficiency With Coolteq.L’s wide dynamic swing range, power consumption is much less dependent on signal PAPR, enabling multiband, multimode PAs to transmit full power high data-rate 20 MHz LTE signals using less energy than today’s singleband 3G PAs. Measured fixed supply instantaneous PA efficiency NCT-L1300 IC Specification Input voltage range 2.5V to 5.25V Output voltage range 0.5V to 4.5V Output power 1.2W average, 4.5W peak RF Channel Bandwidth 20 MHz Efficiency 80% Envelope interface MIPI eTrak/OpenET analog differential Control interface MIPI RFFE Nujira is a proud member of www.nujira.com Nujira Ltd, Building 1010, Cambourne Business Park, Cambourne, Cambridge, CB23 6DP Tel. +44 (0)1223 597900 Fax. +44 (0)1223 597972 Colour Samples Taken 01/02/14 Dark Blue WEB: R = 29% G = 86% PRINT: C = 94% M = 74 Light Blue WEB: R = 0% G = 180% PRINT: C = 69% M = 8% Colour Samples Taken
© Copyright 2024 ExpyDoc