Saturation of MPPC detector ILC meeting 2010/11/11 M2 Hiroko Koike 1 Gain • Over +3V=72.44V Gain (over +3V)=3.5 ×105 dのグラフとgainのグラフ 72.4V d=13.7 counts The value of gain is given as a parameter in the program. d S Gain e A d ( ADCcounts) p.e d' ' d=14.1 counts 2 Plan(last time) A receiving optical side was expanded more than before. MPPC PMT 12mm GATE The setup has not changed. 3 3 When quantities of light are the maximum MPPC MPPC pedestal signal ? PMT pedestal PMT signal 4 4 response curve(last time) MPPC p.e. Fit function (the most simple function) : p0*( 1- exp (- p1 *x /p0 )) p0 : All numbers of expiration pixel p1 : Response ratio Accuracy of a fit is not good. PMT ADC counts 5 To solve theses problems.. MPPC PMT GATE The fiber was concealed. MPPC PMT Above figure : quantities of light are the maximum. Under figure :quantities of light are the maximum. GATE 6 When quantities of light are the maximum MPPC MPPC pedestal signal PMT PMT signal pedestal 7 When quantities of light are the minimum MPPC MPPC pedestal signal PMT pedestal PMT signal 8 8 Angle dependence of polarizing plate to laser MPPC PMT y: ADC pulse height x:rotation step of polarizer (°) Shape of MPPC looks like obviously thinner than PMT . 9 response curve(this time) MPPC p.e. Fit function (the most simple function) : p0*( 1- exp (- p1 *x /p0 )) p0 : All numbers of expiration pixel p1 : Response ratio PMT ADC counts 10 Fit function(crosstalk ,afterpulse) MPPC p.e. MPPC p.e. PMT ADC counts Fit function (effect of crosstalk is additional ) : p0*( 1- exp (- p1 *x /p0 ))* ( 1+p2*exp (- p1 *x /p0 )) p0 : All numbers of expiration pixel p1 : Response ratio p2 : cross talk probability PMT ADC counts Fit function (effect of crosstalk and afterpulse is additional ) : p0*( 1- exp (- p1 *x /p0 ))* ( 1+p2*exp (- p1 *x /p0 )) *(1+p3) p0 : All numbers of expiration pixel p1 : Response ratio p2 : cross talk probability p3 : after pulse 11 • Back up 12 MPPC応答曲線 (生野先輩 2009/02/03 ILC meeting より引用) 13 MPPC応答曲線 (生野先輩 2009/02/03 ILC meeting より引用) Npix=2424 ± 3 と求まった。 14 問題点2について (生野先輩 2009/01/23 ILC meeting より引用) Laser+シンチレータのシステムテスト(まだ光量変えられない) テスト@筑波大 MPP C Inside ビームテストと 同じストリップ 紫外光 レーザー ファイバー 直接 シンチの光 15 16 Measuring imitative chart MPPC単体 MPPC+ scintillator 30mm 20mm 17 前回 To bring the distance of the scintillator and the polarizing plate, the fiber was lengthened. MPPC side PMT side 18 Setup The fiber was extended. 10mm 180mm MPPC PMT GATE Signal of PMT and MPPC When seeing with the oscilloscope 19 When quantities of light are the minimum(前回) MPPC MPPC pedestal signal PMT PMT pedestal signal 20 20 Angle dependence of polarizing plate to laser PMT MPPC y: ADC pulse height x:rotation step of polarizer (°) Shape of MPPC looks obviously thinner than PMT . 21 Response Curve(前々回) MPPC p.e. Fit function (the most simple function) : p0*( 1- exp (- p1 *x /p0 )) p0 : All numbers of expiration pixel p1 : Response ratio PMT ADC counts 22
© Copyright 2024 ExpyDoc