DANGER! HARMFUL OR FATAL IF SWALLOWED. See back panel for other precautions and first aid. NET 32 FL. OZ. (.9463 liters) - 1 qt. For industrial use only. ABC BLACKENER™ is used at room temperature to produce a non-dimensional cosmetic black finish on aluminum, brass and copper. It can be applied by brush-on techniques or used as an immersion solution for more uniform blackening. For best results, the ABC BLACKENER™ finish should be top coated with ABC SEALANT™. • READ MATERIAL SAFETY DATA SHEET BEFORE USING • KEEP FROM FREEZING • Reactivity Flammability 0 Health 2 0 C Personal Protection DANGER: Contains Selenious Acid, may be fatal if taken internally. If swallowed, induce vomiting; call physician. Eye and skin irritant; avoid contact; protect eyes and hands when using. If contact occurs flush with water. Store in acid resistant containers. Keep out of reach of children. • Fast & Safe • Non-Glare Finish • No Heat Necessary 4/12 Black Cosmetic Finish For Aluminum, Brass and Copper Material Safety Data Sheet available on-line at www.precisionbrand.com or call (800) 535-3727 ABC BLACKENERTM HAZARDOUS MATERIAL IDENTIFICATION SYSTEM RATING: 45911 DIRECTIONS Immersion Blackening: 1. Prepare surface, by bead blasting, to remove all oil and oxides. Protect from finger marks or other contamination. 2. Blacken by immersing the part in ABC BLACKENER™ solution. Mix one part ABC BLACKENER™ + three parts water, and contain it in a plastic tub. Be sure to wear rubber gloves. This solution carries out a chemical reaction with the metal. Soak the part with gentle agitation for 30 to 60 seconds or until the part is uniformly gray/black in color. Note: a non-adherent or splotchy finish indicates incomplete cleaning or deoxidizing. 3. Stop the reaction by rinsing with water for at least 15 seconds. 4. Seal the black finish immediately after rinsing off the blackener by immersing the part in ABC SEALANT™ solution, a clear protective top coat. Drying is not recommended before applying sealant by the immersion technique. Brush-On Blackening: 1. Prepare surface, by bead blasting, to remove all oil and oxides. Protect from finger marks or other contamination. 2. Apply ABC BLACKENER™, full strength, with a sponge or brush, using a plastic container as a catch basin. Be sure to wear rubber gloves. Since the solution carries out a chemical reaction with the metal, the best technique is to flood the surface with this liquid, or apply several thin coats, until the part is uniformly gray/black in color. This reaction usually takes about 10 to 30 seconds. 3. Stop the reaction by rinsing with water for 15 seconds. 4. Dry the part with forced air. Be sure to wear eye protection. Wipe any residue off with a soft cloth and seal immediately. 5. Seal the black finish by applying ABC SEALANT™, a clear protective top coat. UPC Part # 45911 Made and printed in the U.S.A. PRECISION BRAND PRODUCTS, INC. 2250 CURTISS ST., DOWNERS GROVE, IL 60515 USA No warranties of any kind are made, expressed or implied (including merchantability or fitness for a particular purpose). Statements or descriptions are informational only.
© Copyright 2024 ExpyDoc
