octoBox waveGen * Radar and Interference Generator Programmable RF waveform generator emulates wireless interference, including radar for DFS (dynamic frequency selection) testing. Controllable via USB or Ethernet/PoE. octoBox™ waveGen™ module emulates common sources of wireless interference to test wireless devices and systems under realistic conditions. waveGen can emulate signals from radar, cordless phones, Bluetooth devices, microwave ovens, baby monitors and other sources of interference. octoBox waveGen is commonly used to test DFS functionality of 802.11h capable Access Points. It can also be programmed to emulate OOK (on/off keying) and frequency hopping devices and can be easily integrated into the octoBox wireless testbed. APPLICATIONS DFS (802.11h) functionality and behavior testing Wi-Fi (802.11a/b/g/p/n/ac), Bluetooth and cellular (GSM, UMTS, LTE, FDD, TD-LTE and LTEAdvanced) testing Throughput vs. range measurements under interference conditions using octoBox-MPE testbed RX interference handling Measurements under controlled signal and noise power settings octoBox waveGen module is exceptionally well isolated and features filtered USB and Ethernet interfaces for power and control. Isolation keeps random interference from entering well-controlled octoBox based wireless testbeds. FEATURES & BENEFITS Frequency range: 25 to 6000 MHz Power output: -2 dBm, typical TX dynamic range: 63 dB of built-in programmable attenuation; step: 0.5 dB Ethernet/PoE power and control interface USB power and control interface PC software configures waveform, its frequency and power level octoBox waveGen waveform generator module octoBox waveGen can generate tones, pulsed tones, OOK or frequency hopping waveforms of programmable amplitude and frequency. Typical radar signal OBS-31 waveGen datasheet +1.978.222.3114 www.octoscope.com octoBox waveGen can be used with the octoBox testbed to measure throughput, mobility, capacity and other performance parameters under interference conditions. octoBox-26 with a waveGen module A waveGen module in combination with octoBox quadAtten module can be mounted on the octoBox to create a variety to test topologies. waveGen can be used to test the ability of APs to detect interfering radar signals and perform a channel switch in compliance with 802.11h DFS protocol. SPECIFICATIONS Parameter Frequency range TX power range RF connector Dimensions Specification 25 to 6000 MHz 63 dB of in-line programmable RF attenuation; 0.5 dB steps SMA Software controls getSerial Returns the serial number (ASCII 0-9999) start –f F –p DB Begin generating DFS Radar signals at frequency ‘F’ (2400-5000) in MHz with power level ‘DB’. (-10 to -70 dBm) stop Stop generating DFS Radar signals CONTACT octoScope, Inc. 305 Foster Street Littleton, MA 01460 Tel: +1.978.376.5841 [email protected] OBS-31 waveGen datasheet +1.978.222.3114 www.octoscope.com
© Copyright 2024 ExpyDoc
