2013 Body Section 3_Body Section 3 4/18/2014 11:22 AM Page 153 MOISTURE BARRIER PLATES – NOP SERIES Moisture Barrier Plates protect the bottom chords of trusses from moisture damage caused by direct contact with concrete. These plates eliminate the need for more expensive treated wood plates. L W NOP1 Installation: • Use all specified fasteners. See Product Notes, page 11. • Pre-attach to truss bottom chord or rafter using prepunched prongs and/or 6d common nails to prevent wood-to-concrete contact. W L 8 8 8 Qty -- -2 2 L NOP2X Dimensions (in) Fastener Schedule1 Steel Ref. No. Gauge W TSS2, TBP8 26 1-7/16 -- -22 1-1/2 TSS2-2 26 3-1/2 NOP4 Type -- -6d 6d Truss & Rafter © Copyright 2013 USP Structural Connectors® Materials: See chart Finish: G90 galvanizing USP Size Stock No. NOP2X 2x NOP1 4x NOP4 L W NOP4 Code Ref. Typical NOP4 installation 120 1) Nails: 6d nails are 0.120" dia. x 2" long. EMBEDDED TRUSS ANCHORS – LPTA SERIES Low profile design attaches to 2 x 4 or larger bottom chords and provides uplift and lateral load resistance. Uplift Materials: 18 gauge Finish: G90 galvanizing Codes: 2031C F2 F1 Installation: • Use all specified fasteners. See Product Notes, page 11. • Embed LPTA 4˝ into concrete tie beam or masonry bond beam. • Anchors should be spaced no closer than 8˝ center-to-center. • Moisture barrier may be required. Dimensions (in) Fastener Schedule2,3 Rafters/Truss USP Steel Stock No. Ref. No. Gauge LPTA LTA2 18 W 5 H 8-1/4 Min 3 Qty. 10 Type 10d x 1-1/2 Typical LPTA installation Allowable Loads (Lbs.) Uplift 1 DF-L / SP S-P-F 160% 1250 160% 1250 F1 F2 W Code 160% 160% Ref. 810 1500 L1 1) Uplift loads have been increased 60% for wind or seismic loads; no further increase shall be permitted. 2) Minimum quantity of fasteners to be installed. Product may have additional nail holes not needed to meet published allowable load of product. 3) NAILS:G[ÝQDLOVDUHÝGLD[ÝORQJ H 1 7/16˝ 1-800-328-5934 • www.USPconnectors.com LPTA 1 3/4˝ USP2241-131 153