ERICO DYNASPHERE MKIV

INSTRUCTION SHEET
ERICO DYNASPHERE MKIV
®
Installation Instructions for 5m Stainless Steel Cantilevered Mast - SIM Series
Terminal Elevation: 4m Above Structure
Mast Detail
(ERICO Part # TCEC253) Copper Tape
ERICO DYNASPHERE
(ERICO® Part # D/SMKIV-SS)
(ERICO Part # PDCUC) Tape Fasteners
SIM28A2
INTCPT ADAPTER
(ERICO Part # INTCPTMIDYN)
Stainless Steel Mast
(ERICO Part # SIM28A2)
SIM33B3
Typical Conductor Connection
Not to Scale
3
-
Bonding Clamp
(ERICO Part # TMCSS)
1
-
39.9mm
2 Holes,
Stainless Steel Cable Tie
(ERICO Part # CABTIESS)
Three every 1m
TMCSS Mast Clamp
Installing contractor to
field adjust and insure a
secure bond on highest
SIM series mast
10.9mm
89.9mm
119.9mm
Downconductor
End View
1m
Stainless Steel Mast
(ERICO Part # SIM33B3)
2
-
1
-
Not to Scale
2
-
Typical ALOF1GS Wall Bracket Base
Not to Scale
Mast Support Bracket
(ERICO Part # ALOF1GS)
Detail "A"
Two downconductors
are required
3
-
Lightning Event Counter
(ERICO Part # LECIV)
Downconductor
Lightning Event Counter
Refer to installation manual
for alternate locations
(ERICO Part # LECIV)
ERICO® CADWELD® Connection
or mechanical connection
Ground Inspection Well
For complete
grounding system
refer to Detail "A"
Crow's Foot
(ERICO Part # GF302)
3m tape enclosed in
GEM material
Minimum 16mm X 2.4m long
ground rod in four locations
Suggested triangular grounding system for each downconductor:
The grounding system shown in the detail is a suggested layout. Each radial consists of a trench
approximately 0.8m deep. The conductor is laid in the trench and is connected to ground rods. The
conductor in each trench is encased in GEM material. Ground rods must extend 3m below ground
level.
Note: This is one of several alternative installation methods.
Refer to ERICO installation manual for more details.
WARNING:
1.
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3.
All instructions must be completely followed to ensure proper and safe installation and performance.
4.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT
www.erico.com
IP79153_A
1 OF 1
© 2014
ERICO International Corporation.

Download Report