O₂ - Automotive Sensor / Type A – 01

Product Specification of:
O₂ - Automotive Sensor / Type A – 01
. : KE Y F EA T UR E : .
Galvanic gas sensor designed for use in automotive exhaust gas analysers, released according to PTB 18.10, meets all
OIML standards and BAR ’02 requirements.
All characteristics are based on conditions at 25°C, 50% RH and 1013 hPa.
Electrical Connector:
Measurement Range:
Accuracy:
Sensor Lifetime:
Expected Operating Life:
Intitial Output Signal:
Response Time t 90:
Signal Response to N2 :
Drift:
Operating Temperature:
Pressure Range:
Influence of Humidity:
Recommended Load Resistor:
Temperature Compensation:
Interferences:
3-pin-Molex 
0 to 25 Vol.%
< 2 Vol.%
± 0.1 %
< 25 Vol.% ± 0.5 %
< 3 years @ ambient air
~ 500,000 Vol.% h
7.0 to 13.0 mV @ dry ambient air
<5s
Ua/200 @ 100% N2 in < 40 s
10 % / year
0 to 50 °C
700 to 1750 hPa
-0.03 % rel. O2 reading per % RH
≥ 10 kOhm
NTC
< 0.1 % O2 response to:
15.0 % CO2 balanced N2
3,000 ppm C3 H8 balanced N2
10.0 % CO balanced N2
500 ppm H 2S balanced N2
3,000 ppm NO balanced N2 500 ppm SO2 balanced N2
1,000 ppm Benzene balanced N2
. : ST OR A GE C ON DI T I ON S : .
Temperature Range:
Ambient Pressure:
Shelf Life:
Weight:
Material in Contact with Media:
recommended: 5 to 25 °C
maximum:
-20 to 50 °C
600 to 1750 hPa
< 6 months recommended
approximately 25 g
PA 12, PPS, PTFE, stainless steel
. : R E LA TE D P RO DUC T S : .
Product
O2 - Sensor A-01M
O2 - Sensor A-01T
O2 - Sensor A-01AVLT
O2 - Sensor A-01ST
Part-No.
44 01 01
47 00 03
47 00 05
47 00 10
Housing Colour
white
translucent
translucent
translucent
Other Specifics
Cap diameter: 31.6 mm
Cap diameter: 31.6 mm
Initial Output Signal: 7.0 to 11.5 mV, Cap diameter: 30.2 mm
Initial Output Signal: 10.5 to 12.5 mV, Cap diameter: 31.6 mm
This data sheet is subject to change without prior notice. [A-01-Rev_012011.doc ]
IT Dr. Gambert GmbH .: Hinter dem Chor 21 .: 23966 Wismar .: Germany
Phone: +49 (0)3841 220 050 .: Fax: +49 (0)3841 220 052 2 .: E-Mail: [email protected]
page 1 of 1
www.itg-wismar.de