NovaSourceTM G7 Synthesized RF Signal Sources Detailed Specifications Parameter Performance Reference Min. Typical Frequency Reference SMA jack selectable as internal reference output or external reference input Internal Reference Frequency 10.00000 Units Max. MHz Initial internal reference initial frequency accuracy (@ +23 +/- 2 deg. C) -1.0 +1.0 ppm Initial internal reference temperature stability, over operating temperature range -1.0 +1.0 ppm 2.0 ppm/yr. dBm,50Ω load Vpk-pk,1MΩ load Vpp Internal reference frequency aging Less than +/- 1.0 Internal reference output level +2 dBm, .8 Vpp External reference input level .06 External reference input impedance Up to 40 600Ω in parallel with 25 pF n/a RF Output RF output power (highest step) +13 +18 n+23 dBm RF output power adjustment 25 Software Controlled in approximately 1dB steps 31 dB Number of Steps Non-harmonic spurious 31 < -60 dBc Harmonics < -35 dBc RF output modes Continuous, Momentary, and Toggle (on/off) RF OFF output level (RF Standby not enabled) RF OFF output level (RF Standby enabled) VCO powered off – no output -45 -65 -70 dBm Lock time (RF Standby not enabled): Ext. trigger falling edge RF within 30 degrees of final phase < 6.0 msec Lock time (RF Standby enabled): Ext. trigger falling edge to RF within 30 degrees of final phase < 6.0 msec External Trigger Input Range 0 Polarity +5.0 VDC Active Low Modulation FM Internal 1 kHz rate, or external DC to 100 kHZ Peak Deviation ± 350 kHz External Input Range -2.50 ±1.25 MHz +2.50 VDC Power Supply DC supply input voltage DC power consumption USB Powered Environmental / Mechanical Temperature range, operating Temperature range, storage Control Interface Control Software Status Indicator LEDs +4.0 1.9 480 -20 -40 +15.0 VDC watts mA +70 +85 °C °C RS-232 serial or USB PC – Windows XP compatible / Windows 7 RF Output ON, Phase Lock, DC Power Supplied Size (W x L x H) 2.75” x 4.0” x 0.75 70 mm x 102 mm x 19 mm in. - mm Weight (not including cables/power supply) Enclosure 5, 140 Extruded aluminum, polycarbonate end-caps oz., g. Finish Epoxy-based paint, white Southern California Microwave NovaSourceTM G7 Synthesized RF Signal Sources Detailed Specifications Continued Environmental / Mechanical RF Output Connector Reference Connector Trigger/Modulation Connector Power Connector SMA Female SMA Female SMA Female 1.3 mm center-positive DC power jack or USB: MicroB Data Connector USB: MicroB, Hirose DF11 By Model Number Part Number NS4-0800102 Frequency - MHz 800 - 3000 Step Size Phase Noise @ 800 MHz (typ) Phase Noise @ 2000 MHz (typ) Phase Noise @ 3000 MHz (typ) 1 kHz -83 @ 1 kHz -84 @ 10 kHz -113 @ 100 kHz -135 @ 1 MHz -78 @ 1 kHz -79 @ 10 kHz -111 @ 100 kHz -133 @ 1 MHz -72 @ 1 kHz -73 @ 10 kHz -108 @ 100 kHz -132 @ 1 MHz L-3 Southern California Microwave 9020 Balboa Ave San Diego, CA 92123-3507 Tel: 858.694.7575 | Fax: 858.694.7525 Email: [email protected] L-3com.com/SCM This technical data and software is considered as Technology Software Publicly Available (TSPA) as defined in Export Administration Regulations (EAR) Part 734.7-11. Specifications subject to change without notice. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders. SCMML706 Rev A Southern California Microwave
© Copyright 2024 ExpyDoc
