UV-5R Manual pofung UV-5R 1 2 3 4 5 6 7 8 9 10 Pre conditions Charge Battery Attach antenna Take Note of: <MENU>, <Up Arrow>, <Down Arrow>, <EXIT>, Orange VFO/MR, BlueA/B, Black BAND, 10 Key Number Pad. Used to enter key numbers Special Keys in the Right column below <EXIT> Turn radio ON, the knob ON / Off volume control Set Frequency Step <MENU> 1 <MENU> select a frequency step to lowest settings Choose “A” Display Blue button <A / B> Enter a receive frequency 145115 NOTE the 5KHz LSD Page 1 UV-5R Manual The receive frequency is the only thing you can enter directly without using the MENU structure. Below are the MENU choices. Using the menu is relatively straight forward after you have used it a while: <MENU>Choice<MENU>setting<MENU> The arrow keys allows you to set receive frequency and scrol through menu choices and setting choices <MENU> MENU Key pneumonia 0 SQL 1 STEP Choice Menu Choice Definition Range 0 – 40 Range Default Squelch Level 0–9 3 Frequency Step 0–5 25.0K Key 0 1 2 3 4 5 2 TXP Transmit Power 3 SAVE Battery Save 4 VOX Voice Operated TX 5 WN Wideband / Narrowband 6 ABR Display Illumination Time 7 TDR 8 BEEP 0–1 Key 0 1 Value in Khz 2.5K 1 5.0K 2 6.25K 3 10.0K 4 12.5K 5 25.0K 1 – 4W Values HIGH 4W HIGH LOW 1 Watt Off-4 3 Off – 10 Off '0 – 1 Key 0 1 0 – Wide Values WIDE 5kHz WIDE NARR 2.5kHz Off – 5 5 Dual Watch 0–1 0 – Off Keypad Beep 0–1 1 – On Page 2 UV-5R Manual 9 TOT Transmission Time-out-Timer 15 – 600 (seconds) 60 Seconds 10 R-DCS Receiver DCS Off, D023N - D754I Off 11 R-CTCS Receiver CTCSS Off, 67.0 - 254.1 Off 12 T-DCS Transmitter DCS Off, D023N - D754I Off 13 T-CTCS Transmitter CTCSS Off, 67.0 - 254.1 Off Number 01 03 05 07 09 11 13 15 17 19 21 23 25 27 29 14 VOICE Voice Prompt 15 ANI-ID Automatic Number ID 16 DTMFST DTMF tone of transmit Frequency 67.0 71.9 77.0 82.5 88.5 94.8 100.0 107.2 114.8 123.0 131.8 141.3 151.4 159.8 165.5 0–1 Number 02 04 06 08 10 12 14 16 18 20 22 24 26 28 30 Frequency 69.3 74.4 79.7 85.4 91.5 97.4 103.5 110.9 118.8 127.3 136.5 146.2 156.7 162.2 167.9 0, ENG 80808 Key 0 1 2 3 Page 3 0, DT+ANI Value Off DT-ST S-CODE only ANI code onlyANI-ST DT+ANI Both Notes UV-5R Manual 17 S-CODE Signal Code 1 -15 1 18 SC-REV Scanner Resume Method 0–2 Key 0 1 2 0, TO Values TO CO SE Time Operation Carrier Operation Search Operation 0–3 Key 1 2 3 0, Off Value BOT EOT BOTH Notes Beginning of transmition End Of Transmit Both BOT and EOT 5 19 PTT-ID When to send the PTT-ID 20 PTT-LT Signal code sending delay 0 – 30 21 MDF-A Channel Mode A Display 0–2 Key 0 1 2 22 23 24 MDF-B 23 BCL AUTOLK Channel Mode B Display Busy Channel Lock-out Automatic Keypad Lock Page 4 Actual codes set by computer only Notes 2, FREQ Values CH Channel number NAME Channel name FREQ Frequency 0–2 Key 0 1 2 2, FRQ Value CH NAME FREQ 0–1 Key 1 0 1, Off Value ON OFF 0–1 Key 0 1 1, Off Value OFF ON Notes Notes Channel number Channel name Frequency Notes Notes UV-5R Manual 25 26 27 SFT-D Frequency Shift Direction 0–2 0, Off Key 0 1 2 Value Off "+ “- OFFSET Frequency shift amount MEM-CH Store a Memory Channel Notes 00.000 Mjz Values (MHz) 00.000 - 69.990 Notes 000 – 127 000 Do 28 first <MENU> 27 <MENU> Chanel <MENU> <EXIT> 28 DEL-CH Delete a memory channel 000 – 127 000 <MENU>28<MENU>Chanel><MENU><EXIT> 29 30 31 WT-LED RX-LED TX-LED Display back-light colour, Standby Display back-light colour, Receive Display back-light colour, Transmit Page 5 0–3 Key 0 1 2 3 0, Off Values Off BLUE ORANGE PURPLE 0–3 Key 0 1 2 3 1, BLUE Value OFF BLUE ORANGE PURPLE 0-3 Key 0 1 2 2, ORANGE Value OFF BLUE ORANGE Notes Notes Notes UV-5R Manual 32 33 34 35 AL-MOD BAND TDR-AB STE Alarm Mode Band Selection Transmit selection while in Squelch Tail Elimination 3 PURPLE 0–2 Key 0 1 2 0, SITE Value SITE TONE CODE 0–1 Key 0 1 0, VHF Value VHF UHF 0–2 Key 0 1 2 0, Off Value OFF A B 0–1 Key 0 1 1, On Value OFF ON 36 RP-STE Squelch Tail Elimination through a repeater 1 – 10 5 37 RPT-RL Delay the squelch tail of re-peater 1 – 10 Off 38 PONMGS Power On Message 0–1 Key 0 1 1, MSG Value FULL MSG 0–1 Key 0 1 0, Off Value OFF ON 39 ROGER Notes Cycling tone over the air Radio speaker only Transmit 5s tone fol-lowed by Morse Notes Notes Upper display Lower display Notes Notes Flash entire LCD Displays a 2 line welcome message Roger Beep Page 6 Notes UV-5R Manual 40 RESET Restore defaults 0–1 Key 0 1 1, All Value VFO ALL Notes VFO settings only Total reset* An example set up for a repeater: Key in 145115 the NCARC #1 2 Meter repeater <MENU>25<MENU>2<MENU><EXIT>. Tto set – DUP offset <MENU>26<MENU>00.600<MENU><EXIT>. To set / verify offset frequency MENU>13MENU>13<MENU>EXIT>. Set CTCSS transmiter encoder tone This should allow the use of the 145115 repeater. Now to store the VFO (Frequency) mode settings into memory <MENU>28<MENU>1<MENU><EXIT>. To clear memory #1 <MENU>27<MENU>1<MENU><EXIT>. To set VFO settings into memory #1 You wouldn't have to program very many channels manually and you will find it tedious. I used the multi platform program CHIRP to enter data into radio MEMORY any or all 125 memory chanels. Page 7
© Copyright 2024 ExpyDoc
