Dismounting of mudguards and remounting at

Dismounting of mudguards
and remounting on the
customer’s premises
Title :
Version: Version
Ref.: Qae-103
no.
Drawn up by:
Examined by:
Approved by:
Samia Labrhaila
First name and Surname of examiners
First name and Name
of approver(s)
Approval date: mm/yyyy
Recommended revision date:
Document type:
Dismounting procedure
Field
Transport
Internal Use. Check validity of this document before application
PURPOSE
THE PURPOSE OF THIS DOCUMENT IS TO SECURE THAT THE DRIVER WILL DISMOUNT THE
MUDGUARDS AND REMOUNT THEM ON THE CUSTOMER’S PREMISES
PEOPLE CONCERNED
Truck drivers
STAKE
Improvement of the loading factor
CONCERNED AREA
Transport
IMPLEMENTATION METHODS
Create a procedure to dismount and transport mudguards safely.
Also enables drivers to remount mudguards according to the Bourg en Bresse plant’s guidelines.
UPDATE
Version
Date
1
2
23/09
06/06
Purpose
Procedure created:
List changes....
Department
Cancels and
replaces
VLC
No document
REFERENCE
List the major direct documents
TITRE DU DOCUMENT
N° QUALITYNET - N°DE VERSION
PAGE 1/5
Description of the stages
Stage 1 : take off the upper part of the mudguard (see picture below)
Stage 2: unbolt the front and rear mudguard support with an angle nut runner (21)
TITRE DU DOCUMENT
N° QUALITYNET - N°DE VERSION
PAGE 2/5
Stage 3: disconnect the lights
Put the protection (cf picture below) i.e. plugs on the connections
TITRE DU DOCUMENT
N° QUALITYNET - N°DE VERSION
PAGE 3/5
Lights with reversing beeper
Put the cable inside as shown in the picture below to protect it
Stage 3: the mudguards are placed on the spare wheel and protected with bubble wrap
TITRE DU DOCUMENT
N° QUALITYNET - N°DE VERSION
PAGE 4/5
Roles and responsibilities
Part 1: Dismounting of mudguards
Person
responsible
Stage
1
TRANSPORT
2
Responsibilities
Dismounting of the mudguards
• Take off the mudguards
• Disconnect the lights
• Put protection i.e. plugs on the connections
• Insulate the wiring harness to avoid any contact with water
• Front and rear mudguard supports are loosened with an angle nut runner (21)
Secure the dismounted parts during transport:
• Protect the mudguards with bubble wrap
• Place them on the spare wheel and strap them to the chassis to ensure that they are safely
transported.
Part 2: Remounting of mudguards on the customer’s premises
Person
responsible
Stage
Responsibilities
Unstrap the mudguards and supports and place them on the ground on the bubble wrap
1
TRANSPORT
TITRE DU DOCUMENT
2
Remounting of the mudguards
• Screw up the front and rear fender supports with an angle nut runner (105N)
• Remove the protection plugs
• Reconnect the lights
• Clip on the mudguards
N° QUALITYNET - N°DE VERSION
PAGE 5/5

Download Report