Datasheet

Anatel Certification
2066-14-8437
UHF Reader EDGE 50 AutoID V2
The UHF RFID reader EDGE-50 AutoID has small dimensions and
great performance, working under Anatel specifications. Perfect for
vehicles access control, since it works with the most common
communication protocols. A tag can be read and communicated via
Ethernet TCP/IP, allowing RFID management software to handle the
access. The EDGE-50 supports up to two mono-static antennas and
requires no software, just connect the reader and it is ready to go.
Purchase Code: 100.247
Characteristics
Small dimensions;
Trigger Read Mode, which the reader reads only when a sensor input is
Supports up to two mono-static antennas of 6dBi, 9dBi or 12.5dBi gain;
detected;
Output RF power up to 1W adjustable separately for each antenna;
Digital Inputs working as either dry contact or wet contact;
Output data via Wiegand 26/34 bits, ABA Track 10/14 digits, Serial
Output relay for each port, set by tag read, digital input or TCP/IP command;
RS-232 and Ethernet TCP/IP, configurable separately for each antenna;
Visual feedback of reader status, IO and antenna ports via LEDs;
Data from Ethernet TCP/IP port compatible with RQL protocol used by
Automatic or manual antenna detection;
other Auto ID System readers;
AutoID Association Logic capable, which improve the overall system security;
Easily configurable via a simple HTML webpage, no software required;
Plug-in Terminal Blocks for easy installation;
ID sent via Ethernet TCP/IP connection can be captured by a Access
Compact and compatible with DIN rail, for even easier installations.
Control software;
The reader keeps reading and sending tags all the time through
Continuous Read Mode;
System Overview
Dimensions [mm]
Controller board
(from Integrator)
Ethernet
TCP/IP
Computer for reader
setup and data received
RST
125
TCP/IP for settings,
tag read and relay commands
ø4,5
Power
Supply
24VDC
100
Mono-static
Antenna
#2
80
Mono-static
Antenna
#1
Through holes for
DIN Rail’s support
RF Cable
112
2 Relay
Outputs
Rev. A.0
3 Modes
• Tag Read
• Digital Input
• TCP/IP Command
RF Cable
2 Inputs
for Trigger
or Relay
e-mail: [email protected] | Phone: +55 11 3028-4600 | www.ACURAGLOBAL.com
The ACURA may, without notice, make changes or improvements to the products, as well as stop its commercialization.
3 Data Outputs: Wiegand 26/34 bits
or ABA TK2 10/14 digits or
Serial RS-232
S1-GND
S1-W0/CLK
S1-W1/DATA
S1-TX
S2-GND
S2-W0/CLK
S2-W1/DATA
S2-TX
52
Switch / Router

Download Report