ENCELIUM® Rocker Switch Wall Stations

www.osram-americas.com/ENCELIUM
Rocker Switch Wall Station
ENCELIUM GreenBus II™
Communication Network
ENCELIUM® Energy Management System – Hardware
ENCELIUM ® Energy Management System Architecture
LCM
Light Fixture
ENCELIUM
GreenBus II
SIM
Occupancy
Sensor
LCM
SIM
Photo Sensor
ECU
PCS/PCW
ENCELIUM Network
FLOOR 2
Wall Station
Network Switch
Secure Ethernet
(existing)
ECU
The Rocker Switch is a single zone lighting controller ideal for small
conference rooms, private offices and other spaces where multi-zone
control is not required. A short press of the upper/lower buttons turns
lighting ON/OFF, while a “press and hold” dims lighting up or down. The
zone status is indicated by an LED with white indicating ON and blue
indicating OFF. Where a lighting zone is controlled by a time schedule
(rather than by occupancy sensors), the Rocker Switch also allows for a
manual override of the time schedule by the press of the upper button
which “re-activates” the zone about to be shut down for a configurable
override period. During the shut down warning mode, the Rocker Switch
will alternately flash the LED from blue to white to indicate to occupants
that an override is necessary.
LMS058R2 3-14
FLOOR 1
SSU
The Rocker Switch (R) is a versatile, low voltage lighting controller that
provides local ON/OFF and dimming control over lighting zones. Meeting
NEMA WDI color specification standards, it connects to the ENCELIUM
EMS through ENCELIUM GreenBus II™ cable with a 2-pin quick connector.
Each Rocker Switch is addressed and configured through the ENCELIUM
Polaris 3D® software interface.
ENCELIUM
Polaris 3D®
System Architecture
This illustration shows how each component is easily integrated into the ENCELIUM
Energy Management System (EMS). ENCELIUM GreenBus II is a two-wire communication topology for supplying data and power to the system. Each light fixture, sensor,
and wall controller is daisy-chained back to the Energy Control Unit (ECU) using
pre-terminated ‘click & go’ ENCELIUM GreenBus II communication cabling. ECUs
typically control individual floors and are linked via an Ethernet Network. Internet or
LAN connection allows floor plan based control software to be operated anywhere on
the network. For reference, the component shown on this data sheet is highlighted.
Ordering Information
Item #
Ordering Description
45253EN-WS-R-GB2-WT
Field Bus
GB2
Modifiers
White
ENCELIUM ® Rocker Switch Wall Stations
0.75”
(19.05mm)
Low voltage ENCELIUM GreenBus II™
connectionto back of lighting controller
Terminal Block
3.81”
(96.77mm)
4.06”
(103.12mm)
Pair 1
GREENBUS II
LINE IN
{
{
1.56”
(39.62mm)
Pair 2
BLACK
BLACK
RED
RED
GREENBUS II
LINE OUT
Crossing pairs is not permitted.
Jacket colors based on ENCELIUM provided wire.
Other wire jacket colors may vary.
To connect ENCELIUM pre-terminated cable to lighting controller:
1. Remove connectors if using ENCELIUM pre-terminated cables.
2. Strip ENCELIUM GreenBus II cable with insulation exposing copper (strip 8mm or 5/16").
3. Depress the locking mechanism.
4. Hold beginning of insulation and insert copper portion of cable into terminal block.
To remove the ENCELIUM GreenBus II cable, depress the locking mechanism.
Specifications
—— Connect to ENCELIUM Energy Management System with 18 AWG, polarity
independent, CMP rated and low voltage wire
—— Lighting scenes reconfigure automatically based on scene changes from
Personal Control Software (PCS)
—— Meets NEMA WD-6 and WD-1
—— Maximum ambient temperature: 60°C (140°F)
—— Mounts in standard size wall box suitable for multi gang installation or,
alternatively, Low Voltage wall plate
—— Suitable for use with decorator-style wall plates
—— These controllers come complete with a single gang mounting plate
Install in accordance with all applicable national and local electrical and building codes.
Americas Headquarters
100 Endicott Street
Danvers, MA 01923 USA
Phone1-800-LIGHTBULB
www.osram-americas.com
OSRAM is a registered trademark of OSRAM GmbH.
ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA Inc.
GreenBus II is a trademark of OSRAM SYLVANIA Inc.
Specifications subject to change without notice.
© 2014 OSRAM
—— Two ports that accept 18 AWG Class 2 Communication Bus for connection
to the ENCELIUM Energy Management System
—— Class 2 Low Voltage device
—— Power through interconnected 18 AWG ENCELIUM GreenBus II cable
—— FCC Part 15/ICES-003
—— cULus Listed
– Energy Management Equipment (UL 916)
—— Complies with the following electromagnetic requirements:
– EN 61000-4-2
– EN 61000-4-4
– EN 61000-4-5

Download Report